Special Functions; Residual Heat Function - Zanussi ZOB 590 User Manual

To cancel the Cooking Duration Time:
- press button until the symbol
- press button " " to decrease the time until "0.00" is
displayed (Fig. 12).
To Programme the Oven to Switch On and Off
1) Carry out the "Cooking Duration" setting as described
in the relevant chapter.
2) Press button until the "End of Cooking" function
is selected and the relevant symbol flashes.
The control panel will display the end of cooking time
(that is, the actual time + cooking duration time - Fig.
13).
3) Press button " " to select the required end of cooking
time.
4) After this is set, the programmer will wait 3 seconds
and then start running.
5) The oven will switch on and off automatically. The end
of cooking will be marked by an acoustic alarm.
6) To switch off the acoustic alarm, press any button.
To cancel the programme, simply cancel the Duration
Time.

Special functions

Automatic Switch-off Function
The oven will switch off automatically if any change of
setting is made, according to the table below (Fig. 14).
If temperature setting is: the oven will switch off:
250°C
from 200 up to 245°C
from 120 up to 195°C
less than 120°C

Residual Heat Function

When a Cooking Duration time is set, the oven will automatically
switch off a few minutes before the end of the programmed
time, and use the residual heat to finish your dishes without
energy consumption. All current settings will be displayed until
the Cooking Duration time is over.
This function will not operate when the Cooking Duration time
is less than 15 minutes.
36
will flash.
after 3 hours
after 5,5 hours
after 8,5 hours
after 12 hours
Fig. 12
Fig. 13
Fig. 14