Setting Recording Audio Levels; Making Timecode And User Bits Settings - Sony SRW-1 Operation Manual

1
Rotate the SELECT/ENTER dial to select the mixing
method.
ADD: Simple addition
RMS: Multiplied average (room mean square)
Average: Simple average
2
Press the SELECT/ENTER dial.
5-2-4 Setting Recording Audio
Levels
To check recording audio levels, use the audio level meters
in the control panel display. The display switches
automatically between recording audio levels during
recording and playback audio levels during playback.
To set the display range of the audio level
meters
The METER TYPE item allows you to set the display
range of the audio level meters.
A U D I O S e t u p
INPUT SEL
PHONE SEL
MIX MODE RMS
REC LEVEL
PB LEVEL
OUTPUT PHASE
METER TYPE PEAK
PEAK HOLD ON
BEEP(PHONE)
C A S S O U T
S RW -1
1
Rotate the SELECT/ENTER dial to select the scale to
display.
Full Peak: Display 0 dBFS as the peak value.
Full Ref: Display the reference level (+4 dBu) as 0 dB.
Fine: Display a scale with steps of 0.25 dB centered
around −20 dB.
2
Press the SELECT/ENTER dial.
To set recording audio levels
The REC LEVEL setting window allows you to set
recording audio levels for the individual channels.
Note
Recording levels cannot be set during playback.
METER TYPE
PEAK PEAK
REF REF
FINE FINE
0 0 : 0 0 : 0 0 : 0 0
TC R
R e c L e v e l
1 2 3 4 5 6 7 8
CH1 4040 CH5 4040
CH2 4040 CH6 4040
CH3 UNI CH7 4040
CH4 UNI CH8 4040
UNI/VAR
C A S S O U T
S R W - 1 T C R
1
Rotate the SELECT/ENTER dial to select a channel (1
to 12).
2
Press the SELECT/ENTER dial.
The current recording level of the selected channel is
shown as a hexadecimal number. UNI is shown for
channels whose recording levels have not been
changed.
3
Rotate the SELECT/ENTER dial to select UNI/VAL,
and press the dial.
If you do not need to change the recording level, set the
recoding level of the channel selected in steps 1 and 2
to UNI and proceed to step 5. If you do need to change
the recording level, set the recoding level of the
channel selected in steps 1 and 2 to VAR and proceed
to step 4.
4
Rotate the ADJUST knob to set the recording level.
Rotate clockwise to raise the level and rotate
counterclockwise to lower it.
To reset the setting
Rotate the SELECT/ENTER dial to move the cursor to
RESET, and press the dial.
5
Press the SELECT/ENTER dial.
6
Repeat steps 1 and 2 to select other channels and steps
3 and 4 to set the recording levels of those channels.
7
When you are finished, rotate the SELECT/ENTER
dial to select END, and press the dial.
5-2-5 Making Timecode and User
Bits Settings
Use the TC Setup menu to make timecode and user bits
settings.
5-2 Recording Preparations and Operations
Cursor
Recording
levels
Channel
9 10 11 12
numbers
CH9 4000
CH10 4000
Recoding level
CH11 4000
settings
CH12 4000
RESET END
00 :00:00:00
55