System Setup Menu - Sony SRW-1 Operation Manual

4-5 SYSTEM Setup Menu

The SYSTEM Setup menu allows you to make system
settings.
In the Settings column of the following table:
Item
FORMAT
Signal format settings
REFERENCE
Reference signal
selection
TEST SG
Test signal output
settings
Note
Both VIDEO and
AUDIO settings
return to the default
OFF when you power
the system off.
48
4-5 SYSTEM Setup Menu
Settings
LINE Sets the number of effective lines and the scanning system.
1080I [1080I]
1080P [1080PsF/P]
FRAME Sets the frame frequency.
23.98 [23.98]: Frame frequency 23.976 Hz
24 [24]: Frame frequency 24 Hz
25 [25]: Frame frequency 25 Hz (field frequency 50 Hz)
29.97 [29.97]: Frame frequency 29.97 Hz (field frequency 59.94 Hz)
SIGNAL Sets the sampling method and video signal recording rate.
422 [4:2:2]: 4:2:2 (Y/Pb/Pr), 440 Mbps
422x2 [4:2:2 Dual]: 4:2:2 (Y/Pb/Pr) DUAL STREAM, 880 Mbps
444SQ [4:4:4 SQ]: 4:4:4 (R/G/B), SQ mode, 440 Mbps
444HQ [4:4:4 HQ]: 4:4:4 (R/G/B), HQ mode, 880 Mbps
Note
Tapes recorded with the 444HQ setting cannot be played back on the SRW-
5000/5500.
MODE Selects the input signals to use as reference signal.
INP [Input]: Video signals input to the HD SDI IN A/B connectors.
EXT [External]: Signals selected with the next item EXTERNAL.
EXTERNAL When the previous item MODE is set to EXT, selects the signals to use as
reference signal.
HD [HD]: During playback and audio signal recording, use an HD tri-level sync
SD [SD]: When the frame frequency is 29.97 Hz or 25 Hz, use a VBS signal
HD&SD [HD&SD]: When the frame frequency is 23.98 Hz, use an HD tri-level
VIDEO Determines whether to make the internal video signal generator generate a
test signal.
OFF [Off]: Generate no test signal.
CB [Color Bar]: Generate a color bar signal.
BLK [Black]: Generate a black signal.
AUDIO Determines whether to make the internal audio signal generator generate a
test signal.
Settings for internal audio signal generator
OFF [Off]: Generate no test signal.
1KHz [1KHz]: Generate a sine wave signal of 1 kHz.
NONE [Silence]: Generate a muted signal.
• Default settings are underlined.
• Square brackets indicate settings as displayed in setting
windows (see the figure for step 3 on page 51).
signal input to the REF IN HD connector.
input to the REF IN SD connector.
sync signal input to the REF IN HD connector, and a VBS signal input to
the REF IN SD connector.