Connecting The Power Adapter; Battery; Operation Without A Battery Pack; Operation With A Battery Pack - Intelligent Weighing Technology Intell-Print OM7212 User's Operation Manual

3.3

Connecting the Power Adapter

This printer requires an external power supply. An approved Class 2 power supply is required for the operation of this product.
1. Make sure the power switch is turned off.
2. Insert the output plug of the power adapter into the printer DC jack.
3. Plug in the adapter or the power supply's cord to an outlet.
4. Only use one of the following OMNIPrint adapters:
OMPS7205-915-NA
OMPS7205-915-EU
OMPS7205-1220-SMPS
3.4

Battery

3.4.1

Operation Without a Battery Pack

If your printer has dip switches then the sliding switch in the dip switch well must be set so the actuator is adjacent to the dip
switches. If your printer does not have dip switches, and has been specified to operate without a battery, then no configuration is
necessary. The printer power must be off before actuating any of the switches in the dip switch well. If your printer does not
have dip switches, and has not been specified to operate without a battery, then it must be operated with a battery pack.
Pack
If your printer has dip switches then the sliding switch in the dip switch well must be positioned away from the dip switches. The
printer power must be off before actuating any of the switches in the dip switch well. If your printer does not have dip switches
then no configuration is necessary to operate with a battery.
3.4.3

Charging procedure

(120 VAC input)
(220-240VAC input)
(90-240VAC input)
Output: 12VDC 2.0A , 2.1mm x 5.5mm female plug , Center positive.
Actuator adjacent to dip switches 3.4.2
Actuator away from dip switches
Operation With a Battery