Replacing The Battery Pack - Intelligent Weighing Technology Intell-Print OM7212 User's Operation Manual

3.4.4

Replacing the Battery Pack

Renew the battery pack if it discharges within an extremely short time.
1. Replace the cell with:
Li-ION 8.4V, 1800 mAH, OMNIPrint Part No.: OMBP-7212-18, or Li-ION 8.4V, 2400 mAH, OMNIPrint Part
No.: OMBP-7212-24
Use of another cell may present a risk of fire or explosion. Replacement cells can be obtained from OMNIPrint by visiting
www.omniprintinc.com.
CAUTION: The cell used in this device may present a fire or chemical burn hazard if mistreated. Do not disassemble, heat
above 100°C (212°F), or incinerate.
2. Turn the printer off.
3. Turn the printer over. Open the battery lid using the tip of your finger, a coin, etc. Avoid using a sharp object.
4. Take the battery pack out by pulling on the ribbon wrapped around it.
5. Disconnect the battery connector and remove the battery pack. Install the new
battery pack and attach the battery connector in the correct direction. Please
note that the connectors are keyed to ensure the right polarity is maintained.
6. Attach the battery cover.
7. Dispose of used cell promptly. Keep away from children.
Make sure you turn off the power switch.
Do not disassemble the battery pack.
Hold the connector body not the lead, when disconnecting the battery connector.
Do not short-circuit the battery pack terminals.
Do not throw the used battery in fire.