Table of Contents
Advertisement
3.6
Loading Paper
Use a paper roll that meets the specifications. Do not use paper rolls that are glued to the core. Make sure data is not being
transmitted to the printer while loading paper.
1.
Open the printer paper cover by firmly holding the printer in one hand and
gently lift the paper cover by applying an equal force on both sides.
2.
Remove the old paper roll, if any, by gently removing the spindle from the roll
holder. Do not pull the paper out of the printer. Always use the FEED button.
3.
Put the spindle inside the new roll's core and gently insert it on the printer's roll
holder until it snaps in on both ends.
4.
Align the paper so it is straight and its core is parallel to the spindle. Make sure the paper is curling up.
5.
Pull the paper so that the leading edge of the paper goes at least two inches beyond the printer tear bar.
6.
Close the printer paper cover and make sure its snaps in on both ends.
7.
Press the FEED button to make sure the roll is properly loaded. If you notice
any wrinkles or creases on the edges of the paper try loading the paper again.
8.
Tear the excess paper against the serrated edge.
NOTE: You do not have to use the spindle but it is recommended in order to: 1) Reduce tension on the paper; 2) Stop the roll
from rattling inside the cover in portable applications.
Advertisement
Table of Contents
