Table of Contents
Advertisement
5
Control Panel The control panel features one button and three LEDs
POWER SWTICH: The power switch is a slide type located in the rear of the printer. Use this switch to power the printer, reset,
or get the printer out of sleep mode.
FEED BUTTON: Press the FEED button once to advance one line or hold down for continuous paper feeding.
POWER LED: Green LED, when blinking, indicates power is on. Red LED, when blinking, indicates low battery.
ERROR LED: Red LED, when blinking, indicates an error condition. The most common error conditions are out of paper, cover
open.
CHARGER LED:
a) Green indicates the battery if fully charged.
b) Red indicates battery is charging.
c) When the adapter is not plugged in the Charger LED will be off.
6
Running the Self Test
Any time you want to check the performance of your printer you can run the self test as follows:
1.
While holding down the FEED button, turn the printer on.
2.
The printer prints the model name, and firmware revision installed along with other configuration information.
3.
The printer will automatically stop printing at the completion of the self test. If the FEED button is pressed again, a
character pattern will be printed. If the printing the character test pattern is not desired, cycle the power on the printer to
resume normal operation.
NOTE: THE PRINTER MAY GO OFF LINE AND WILL NOT COMMUNICATE WITH THE HOST WHILE IT IS IN SELF TEST
MODE.
Advertisement
Table of Contents
