Table of Contents
Advertisement
3.7
Attaching the Belt Clip
Please follow the following procedure if you desire to use the included belt clip:
Turn the printer over. Hold the printer such that the IrDA window is towards you. You will notice two rectangular holes
in the middle of the printer case.
Hold the belt clip facing the outside surface.
Insert the belt clip's front tab perpendicularly into the hole closer to you.
Lower the belt clip until its other tab goes inside the second hole. The clip must be in a horizontal position parallel to the
printer bottom case.
Press the belt clip's edge away from you towards you until it snaps in.
Advertisement
Table of Contents
