Table of Contents
Advertisement
8
REGISTRATION
IMPORTANT: When you purchase a phone system, all handsets are already registered to
your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if a handset has
become faulty.
You can register additional handsets to have up to five handsets per base unit, with each
handset's number (1 to 5) shown on its display.
(Note: each handset can only be registered to one base.)
To check whether a handset is registered, make sure mains power to the base unit is
switched on and the handset is within range. The handset's display should show its number
> should be steadily on. If the display shows "REGISTER", you need to
and the <
register the handset again using the following process:
On the cordless handset:
1.
Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
2.
Press <MENU/OK> to display "PIN ?", enter the 4-digit PIN code for the base
(default PIN code is 0000).
3.
Press <MENU/OK> and the display will flash "SEARCHING".
On the base:
4.
At the same time, press <MENU/OK> and <UP/DOWN> to select REGISTRATION.
5.
Press the <MENU/OK> to see "SEARCHING" flashing on the base display. After a
short delay, if the registration is successful, there will be a confirmation beep, and
the Handset display will go back to idle mode with the new handset number shown.
The base display will also go back to idle mode.
6.
Lift the corded handset up of the base at any time to cancel.
Trim size: 148mm(W) x 210mm P38
39
Advertisement
Table of Contents
