Omron RX Series User Manual page 35

No. Key image
7
8
9
10
11
12
*1 Check the KEY ENABLED indicator (RUN command LED indicator).
Precautions for Safe Use
• Provide a separate emergency stop switch because the STOP key on the operator is valid
only when function settings are performed.
• The FWD RUN, REV RUN, and STOP/RESET keys are disabled while the Inverter parameter
settings are all read or written. Perform the all read/write functions during Inverter stop.
LCD Digital Operator User's Manual (I579)
Name
Moves the cursor down.
It is also used to decrease the parameter number or parameter
Decrement key
value.
Moves the cursor to the left.
In Navigation level display mode, moves to the previous mode.
PREV PAGE key
Moves the cursor to the right.
In Navigation level display mode, moves to the next mode.
NEXT PAGE key
Runs the motor in the forward direction.
This key is enabled in the following cases.
• The remote mode is enabled by pressing the LOCAL
REMOTE key for 2 seconds (the remote LED is lit).
*1
FWR RUN key
• RUN Command Selection (A002) is set to "02: Digital
operator".
• The forced operator function is enabled by the multi-function
input which is set the forced operator function (OPE).
Runs the motor in the reverse direction.
This key is enabled in the following cases.
• The remote mode is enabled by pressing the LOCAL
REMOTE key for 2 seconds (the remote LED is lit).
*1
REV RUN key
• RUN Command Selection (A002) is set to "02: Digital
operator".
• The forced operator function is enabled by the multi-function
input which is set the forced operator function (OPE).
Stops the motor, or resets the alarm.
When the parameter b087 (Stop key selection) is set to "01:
Disable," this key is enabled in the following cases only.
• The remote mode is enabled by pressing the LOCAL
STOP/RESET key REMOTE key for 2 seconds (the remote LED is lit).
• RUN Command Selection (A002) is set to "02: Digital
operator".
• The forced operator function is enabled by the multi-function
input which is set the forced operator function (OPE).
2 Part Names and Functions
Function
2
2 - 5