Start Pairing; Pairing Procedure - ELECTROCOMPANIET ECI 6DS Owner's Manual

ENG
ECT 4 Remote Control

Start Pairing

To be able to use the ECI 6DS with ECT 4 the two devices have to be
paired once. In the pairing process the devices exchange some necessary
data like device ID, RF address, etc. After pairing success, ECI 6DS will be
added to the device selection screen of the ECT 4 and can be used. Pairing
mode has to be started on both ECI 6DS and ECT 4. In addition, ECT 4
and ECI 6DS have to be in close proximity to each other. Pairing can be
canceled by pressing "Go back", "Stop" or "Navigate left". Hotkeys,
"Zone selection" and "System" key work as well.

Pairing procedure

1. To start the pairing procedure:
Press button , select "Start pairing" and
press the "Enter" button.
The following screen will be displayed (image 1)
2. Turn on the main switch of ECI 6DS immedi-
ately after pressing "Enter" on ECT 4. (image 2)
image 1
image 2
3. When pairing is successful, set the name of
the device found.
If there is no response in time, you will be
informed (image 3) and can try the pairing pro-
cedure again. Turn of the ECI 6DS and repeat
the procedure from the beginning.
image 3
9