Mounting The Projector - Meridian D-ILA1080MF1 User Manual


I n s t a l l i n g t h e
d i g i t a l v i d e o
p r o j e c t o r
Mounting the projector
The projector can be operated in a free-standing position using the feet supplied. To mount
the projector, remove the 4 feet and make use of the 4 screw holes (M8 nuts) on the
underside of the projector. Allow sufficient space around the air inlets to avoid blocking
them.
Precautions for ceiling-mount
To ceiling-mount this unit, special expertise and techniques are necessary. Be sure to ask
your dealer (or a specialist) to perform mounting (to ceilings, etc.).
• Do not mount in places that may be subjected to vibration and shock.
• The depth of the threaded holes is 30 mm. Use screws shorter than 30mm but longer
than 19mm. Longer screws may damage internal parts of the projector and cause
malfunction.
• Safety of the installation location should be considered in case this unit, or a part of it,
falls. Note that if the light-source lamp is broken, glass shards from the filter mesh may
spread outside the projector.
Minimum space required
150mm and above
300mm and
above
150mm and
above
Do not use a cover which may enclose this unit or block the air inlets/exhaust vents. Allow
sufficient space around this unit. When this unit is enclosed in a space of dimensions as
indicated above, use an air-conditioner so that internal and external temperatures are the
same.
300mm and
above
500mm and
above