Controls - Right Side And Rear - Meridian D-ILA1080MF1 User Manual

 0
O p e r a t i n g t h e
d i g i t a l v i d e o
p r o j e c t o r
Controls – right side and rear
A: Control Panel Cover
Remove this cover when operating this unit without the remote control or when replacing
the lamp unit.
• Unlock the cover, followed by sliding it downwards to remove it.
Please refer to Control panel , page 11, for details of the control panel.
Handling the Control Panel Cover
The gap between the body of the unit and the control panel cover is narrow. Be careful not
to stick your finger into the gap between the body of the unit and the control panel cover.
After attaching the control panel cover, check that the lock is fastened securely.
B
C
A
Release
Lock
B: Exhaust Vent
Warm air is expelled through this vent to keep the system cool. Do not block the exhaust
vents as this may cause the unit to overheat and fail.
C: AC Power Input Socket
This is the AC power input socket. Connect the supplied power cable to this socket.
D: Screen Trigger socket
This socket is used for controlling a motorised screen. An output at DC +12 V/100 mA
(max.) is produced when the power is on.
D E F G
Consult a qualified technician for a connection with the screen.
SCREEN TRIGGER SERVICE RS-232C DVI
E: Service Connector
This connector is intended for servicing purposes and should not normally be used.
F: RS232C Serial Port (D-sub 9 Pin)
The projector can be controlled by serial commands from a computer or home automation
control system connected to this port.
For details, please check with your authorized dealer.
G: DVI input (DVI-D 24 Pin)
This is the input socket for video signals. 1080/50p and 1080/60p signals are supported
and HDCP content protection capability is provided.