Warning Indicators - Meridian D-ILA1080MF1 User Manual

A representation of a lens is shown with an 'X' through it and
the words, 'not available'
Shown when pressing the ZOOM T/W or FOCUS +/- button when the Zoom/Focus setting
in the OPTIONS menu is set to Lock.
• Go to the OPTIONS menu and set Zoom/Focus to Unlock.
Lamp replacement
As soon as the accumulated lamp time reaches 1900 hours, a Lamp replacement
message is displayed. In addition, when the accumulated lamp time reaches between 1900
hours to 2000 hours, the Lamp replacement message will be displayed each time the
projector is turned on.
• The message can be cleared by pressing any button on the remote control or on this
unit.
Get a new lamp unit ready in advance or replace as soon as possible.
Lamp replacement Warning
The Lamp replacement message will be displayed and the word 'Warning' will appear
blinking beneath when the accumulated lamp time exceeds 2000 hours.
• The message can be cleared by pressing the EXIT button. However, the same message
will reappear every hour.
When the accumulated lamp time exceeds 2000 hours, the projector cannot be turned
on again once it is switched to the standby mode or turned off. If continuous projection
is performed after 2000 hours, the unit will shut down upon exceeding 2010 hours and
projection will be disabled.
Install a new lamp unit and reset the lamp time.
Warning indicators
About warning indicators
If a problem occurs in the unit during projection, the warning mode will be triggered and
the type of problem will be identified by a combination of indicators displayed on the top
surface of the projector.
• The projector will then automatically cease projection and run the cooling fan for about
60 seconds.
No. Indicator
LAMP TEMP FAN HIDE
1 Light on Blinking Blinking
2 Light on Blinking Blinking
3 Blinking Blinking
4 Blinking Blinking
5 Light on Blinking
6 Light on Blinking
7 Light on Blinking Blinking
8 Light on Blinking
Actions to be taken following display of warning indications
Please follow the procedures below.
For Nos. 1 - 4
No. 1: Perform procedures to turn off/on the power again.
No. 2: After checking if an impact shock has not occurred during operation, perform
procedures to turn off/on the power again.
WARNING
Lamp does not light up and unit is
unable to project.
Lamp turned off during projection.
Circuits are not functioning properly
(Microcomputer Circuit Operation).
Circuits are not functioning properly
(Drive Circuit Operation Error).
Lamp cover is not installed.
Internal temperature is abnormally high
(Internal Temperature error).
Temperature at air inlets is high
(External Temperature Error).
Internal fan has stopped (Fan jammed).
 
M a i n t e n a n c e a n d
t r o u b l e s h o o t i n g