Remote Control - Meridian D-ILA1080MF1 User Manual

Remote control
Digital video projector
operation
The remote control operates both Meridian
DILA projectors and DVP digital video
processors.
• Press DVP or DILA to select the
product you want to control.
• Point the infra-red light at the top of
the remote control towards the product
you want to control.
The digital video processor has an infra-red
sensor on the front panel.
The projector has an infra-red sensor at
the front. You may be able to control the
projector by pointing the remote control at
the screen so the beam reflects back to the
projector.
To work reliably the angle of the beam
needs to be within ±30° of centre, and
the total distance needs to be less than 7
metres.
Select projector
Select processor
DVP DILA
Reset a selected menu item
Profile
to factory setting
Preset
Navigate menus
Enter
Select menu item
Return from menu
Bypass
Exit
DVI
Video S-Video
Select aspect ratio
Anamorphic 4:3
Adjust colour
Colour Tint
using < or >
1 2
Display green grid signal
for focus adjustment
Pattern Focus
4 5
7 8
Hide/restore video image
Hide Zoom
0
Adjust brightness
Bright.
using < or >
Illuminate backlight for 10
Lig ht
seconds
Turn processor/projector on
On
Turn processor/projector
Off
to standby.
Hold down or switch
Store
projector to cool-down
mode
Display/hide menu
Menu
YCrCb
Select video input
RGB
Adjust NTSC tint
Letterbox
using < or >
Detail
Adjust image detail
using < or >
3
Adjust projector focus
6
9
Display test patterns
T
Zoom projector image
Test
W
Cont. Adjust contrast
using < or >
To replace the batteries
Before use, fit 3 AAA size batteries into the
remote control. If the remote control starts
to function erratically, replace the batteries.
• Gently press the circular recess near the
top of the battery cover on the back of
the remote control.
• Slide the cover down and off.
• Insert three penlight cells by pressing
the negative terminal of each battery
against the corresponding spring and
snapping into place.
Alkaline cells types AAA, UM04 or IECR03
are recommended.
The correct orientation of the batteries is
indicated in the battery compartment.
• Replace the battery compartment cover
and slide it upwards, engaging the
two tabs at the top of the cover with
the slots provided at the top of the
compartment.
• Push the cover up until it clicks shut.
When correctly engaged, the cover should
sit flush with the rear of the remote
control.
 
O p e r a t i n g t h e
d i g i t a l v i d e o
p r o j e c t o r