Resetting Lamp Time - Meridian D-ILA1080MF1 User Manual

Tighten the screws of the lamp unit and fold down the handle
• Fasten the 2 screws with a Philips head screwdriver.
Re-attach the lamp cover and fasten the screw
• Fasten the screw with a Philips head screwdriver.
Note: When fitting the lamp cover, insert the left end (with 2 claws) of the lamp cover
into the unit, followed by ensuring that the protruding part on the reverse side of the lamp
cover fits snugly into the recess. As this protrusion acts as a switch, misfitting may stop the
projector from operating.
Re-attach the control panel cover
Control Panel cover
Handling the Control Panel Cover
• The gap between this unit and the control panel cover is narrow. Be careful not to trap
your finger in the gap between the projector body and the control panel cover.
• Be careful of the protrusions and corners of components to avoid injury.
• After attaching the control panel cover, check that the lock is fastened. The control
panel cover may drop and cause injury.
Resetting lamp time
After installing a new lamp unit, the lamp time must be reset before the projector can be
used. Resetting the lamp time resets the internal counter to zero hours.
Note: If the previous lamp had accumulated over 2000 hours of use, the projector will not
operate until the lamp time has been reset.
Reconnect power to the projector
• The main power turns on and the Standby indicator on the unit lights up.
Point the remote control unit at one of the sensors on the projector.
• Press EXIT, ENTER and HIDE, one after the other, on the remote control.
• Press V for 2 seconds or more.
• The STANDBY and OPERATE indicators will blink alternately for a total of 3 seconds.
After the blinking stops, lamp time resets and the unit returns to the standby mode
(STANDBY indicator lights up). The lamp time counter has now been reset and a new count
will start.
If the accumulated lamp time has reached 2000 hours, the projector will not function (lamp
will not light up) unless the lamp time is reset.
Check the lamp time has been reset
Fasten the lock
on the Control
The lamp time can be checked via the Lamp Time option on the INFORMATION menu.
Panel cover
 
M a i n t e n a n c e a n d
t r o u b l e s h o o t i n g