Meridian D-ILA1080MF1 User Manual page 31

Symptom Probable cause
Video images are Has setting been
missing performed for screen
mask?
Has setting been
performed for picture
shift?
Remote control unit Are batteries installed
does not work correctly?
Are batteries exhausted?
Is there any obstruction
between the remote
control unit and remote
sensor?
Is the remote control
held too far away from
the sensor?
• This projector employs a microcomputer. Excessive external electrical and RF noise may
cause it to lock up. If this happens, turn the unit off, disconnect the power, wait at least
ten seconds and then re-power the unit. Check the projector's operation again and if
problems persist, contact your dealer.
Corrective action
Set the Mask setting of the Setup
menu to Off.
Alter the Picture Shift value in the
Setup menu to ensure that images
are not missing.
Match the polarities (+ or -)
correctly when inserting batteries.
Replace with new batteries.
Remove any obstruction.
Hold the remote control closer to
the sensor when using.
 
M a i n t e n a n c e a n d
t r o u b l e s h o o t i n g