Table of Contents
Advertisement
3.5
Internal connectors
1.
Intel
C226 Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1-6 [yellow])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
•
•
•
3-14
These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID
Mode]. Refer to section 4.6.3 SATA Configuration for details.
Before creating a RAID set, refer to section Chapter 5 RAID configurations or the
manual bundled in the motherboard support DVD.
When using NCQ, set the SATA Mode in the BIOS to [AHCI Mode]. Refer to section
4.6.3 SATA Configuration for details.
Chapter 3: Motherboard information
Advertisement
Table of Contents
