Table of Contents
Advertisement
3.
Secure the SSD in place with four
screws.
Swing the drive cage
outwards to access the two
screw holes on the other side
of the drive cage.
4.
Connect a 7-pin SATA cable
(from the motherboard SATA
port) and a 15-pin power plug
(from the power supply unit) to
the rear connectors of the SSD.
Use either the 15-pin SATA power connector or the legacy 4-pin power
connector. Do not use both types of power connectors to prevent damage to
components.
2-20
Chapter 2: Hardware setup
Advertisement
Table of Contents
