Table of Contents
Advertisement
PS/2 Keyboard and Mouse Support [Auto]
Select any of these settings when PS/2 keyboard and mouse are installed. These
settings only apply when Fast Boot is enabled.
[Auto]
[Full Initialization]
[Disabled]
Network Stack Driver Support [Disabled]
[Disabled]
[Enabled]
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot]
[Fast Boot]
HW Fast Boot [Disabled]
Allows the system to enable or disable the HW Fast Boot.
Configuration options: [Disabled] [Enabled]
DirectKey Enable [Go to BIOS...]
[Disabled]
[Go to BIOS
Setup]
Boot Logo Display [Enabled]
[Enabled]
[Disabled]
Boot Logo Size Control [Auto]
[Auto]
[Full Screen]
4-44
For a faster POST time, PS/2 devices will only be
available when the system boots up or rebooted when the
PS/2 devices have not been reconnected or changed. If
you disconnect or change PS/2 devices before restarting
the system, PS/2 devices will not be available and BIOS
setup program will not be accessible via PS/2 devices.
For full system control, PS/2 devices will be available
during POST at any circumstances. This process will
extend POST time.
For the fastest POST time, all PS/2 devices will not be
available until your computer enters the operating system.
Select to skip the network stack driver from loading during POST.
Select to load the network stack driver during POST.
Returns to normal boot on the next boot after an AC power loss.
Accelerates the boot speed on the next boot after an AC power loss.
Disables the DirectKey button. The system will only power on or off
when you press the DirectKey button.
Allows the system to power on and go to the BIOS Setup directly when
you press the DirectKey button.
Enables the full screen boot logo display during POST.
Disables the full screen boot logo display during POST.
Automatically adjusts for Windows
Maximizes the boot logo size.
requirements.
®
Chapter 4: BIOS setup
Advertisement
Table of Contents
