Table of Contents
Advertisement
DO NOT throw the motherboard in municipal waste. This product has been designed to
enable proper reuse of parts and recycling. This symbol of the crossed out wheeled bin
indicates that the product (electrical and electronic equipment) should not be placed in
municipal waste. Check local regulations for disposal of electronic products.
DO NOT throw the mercury-containing button cell battery in municipal waste. This symbol
of the crossed out wheeled bin indicates that the battery should not be placed in municipal
waste.
About this guide
Audience
This user guide is intended for system integrators and experienced users with at least basic
knowledge of configuring a workstation.
Contents
This guide contains the following parts:
1.
Chapter 1: Product Introduction
This chapter describes the general features of the workstation, including sections on
front panel and rear panel specifications.
2.
Chapter 2: Hardware setup
This chapter lists the hardware setup procedures that you have to perform when
installing or removing system components.
3.
Chapter 3: Motherboard information
This chapter gives information about the motherboard that comes with the workstation.
This chapter includes the motherboard layout, jumper settings, and connector
locations.
4.
Chapter 4: BIOS information
This chapter tells how to change system settings through the BIOS Setup menus and
describes the BIOS parameters.
5.
Chapter 5: RAID configuration
This chapter provides information on how to configure your hard disk drives as RAID
sets.
6.
Chapter 6: Driver installation
This chapter provides information on how to install the drivers for system components.
This chapter also describes the software applications that the barebone workstation
supports.
7.
Appendix: Reference information
This section provides a troubleshooting guide for solving common problems when
using the barebone workstation.
x
Advertisement
Table of Contents
