Senso Oxygen Purity Indicators (Lx O Sensor Model); Initial Startup Of The Concentrator; Explanation Of Oxygen Purity Indicator Lights - Invacare Platinum IRC5LXAW Operator's Manual

SECTION 5—OPERATING INSTRUCTIONS
NOTE: The use of some accessories such as the pediatric flowstand
and the HomeFill compressor will deactivate the Low Flow Alarm.
Flow Knob
Ball
FIGURE 5.6 Flowrate
SensO Oxygen Purity Indicators (LX O
2 2
Sensor Model)
This feature monitors the purity of oxygen generated by the
oxygen concentrator. If purity falls below factory preset
standards, indicator lights on the control panel will illuminate.

Initial Startup of the Concentrator

NOTE: Concentrator may be used during the initial start warm‐up
time (approximately 30 min.) while waiting for the O purity to
2
reach maximum.
When the unit is turned on, the GREEN light will come on
(SYSTEM OK/O greater than 85%). After five minutes, the
2
oxygen sensor will be operating normally and will control the
indicator lights depending on oxygen concentration values.

Explanation of Oxygen Purity Indicator Lights

NOTE: For this procedure, refer to FIGURE 5.7.
Part No 1134866 25 Platinum™