Table of Contents
Advertisement
5.
Hook the metal brackets of the rear board over the screws
you loosened, as shown in the illustration .
6.
Use four screws
(M5 x 20 mm) to provisionally fasten the
B
pedal board .
7.
Securely tighten the two side board screws and four pedal
board screws .
* When attaching the rear board, before tightening the screws, adjust things as
necessary at all the points where there are screws so as to assure that the rear
board is aligned in parallel with the pedal board .
Rear view
6.
Screws
7.
x 4
B
8.
Set the speaker box so that the speaker cable is above it, and
align the holes in the metal parts on the inner side of the
side boards with the holes in the speaker box .
9.
Attach the speaker box to the metal parts on the inside of
the side boards from underneath using screws
mm) . Then fasten the rear with screws
well .
2. Install the Piano onto the Stand
1.
Align the screws on the bottom of the piano (one each at left
and right) with the metal brackets on the side boards . Then,
while lifting the front of the piano one or two centimeters,
pull it toward yourself so that the screws engage the metal
brackets .
* When handling the piano, fi rmly grasp it . Be careful, so you do not get your
fi ngers pinched .
2.
Fasten the piano to the stand with the screw
Screw
B
5.
B
7.
Screws you loosened in step 4
(two screws)
(M5 x 20
B
(M5 x 20 mm) as
B
Rear view
Screws
B
x 4
(M5×20 mm) .
B
1.
Pull the piano
toward yourself
while keeping
the front slightly
raised .
2.
Please don't
get your fi ngers
Screw
B
pinched .
3.
Connect the speaker cable to the speaker connector on the
bottom of the main unit, connect the Power cord to the AC
In jack, and connect the pedal cord to the Pedal connector .
Speaker cable
4.
As needed, use the plastic-coated clips on the bottom of the
piano to secure the power cord and pedal cord .
5.
Fasten the headphone hook
16 mm) .
6.
Adjust the Adjuster
Turn the adjuster to lower it until the adjuster is in fi rm contact with
the fl oor. In particular, when you've placed the piano on carpet, you
must turn the adjuster until it is pressing fi rmly against the fl oor.
* The pedal may be damaged if there is a gap between the adjuster and the
fl oor .
When Moving the Piano
When you need to move the unit, you should fi rst close the keyboard cover,
detach the Power cord, and raise the adjusters of the stand. When moving the
unit, at least two people should work together and lift the unit carefully, all the
while keeping it level, and being very careful so as not to pinch your hands or
drop the unit on your feet.
*
5
1
0
0
Power
Pedal
cord
cord
Coated clip
using screws
(M4 x
D
C
Screw
x 2
C
Adjuster
0
2
5
3
7
8
-
0
2
*
63
Advertisement
Table of Contents
