Table of Contents
Advertisement
91-000832_E5644B CIB_R4.qxd
Appendix
Adding new handsets
You can add a new handset (E560-2, purchased separately) to the E5643B at any time,
but the new handset must be registered with the base before use.
The E5643B has 3 handsets automatically registered as Handset 1, 2 and 3. You can
register one additional handset, which will be assigned number 4.
The E5644B has 4 handsets automatically registered as Handsets 1, 2, 3 and 4. You
cannot register any additional handsets to the E5644B.
NOTE: You can replace E5644B handsets (see page 39-40).
Enter base ID, then press SELECT.
ENTER BASE ID
HANDSET 2
Handset 1
Handset 2
Handset 4
2/13/1950
Before using a new E560-2 handset, you must register it
with the base. During registration, you must enter the
15-digit ID number of the telephone base. The Base ID is
located on the bottom of the base unit.
To add a new handset:
• Make sure your handset battery is properly installed
and charged.
• Your handset will display "ENTER BASE ID".
• Enter the 15-digit Base ID number from the bottom
of the base unit (E5643B).
• Press
istration.
NOTE: If an invalid Base ID code is entered, you will hear an error
Handset 3
tone and the handset will continue to display "ENTER BASE ID". To make cor-
rections while entering the code, you can erase digits by pressing the
DELETE key.
Once a valid base ID code is entered and accepted , the
new handset will be assigned the next available handset
number. You can register a maximum of four handsets
per base unit.
7:21 PM
Page 38
to accept the code and complete reg-
SELECT
38
Advertisement
Table of Contents
