Adding New Handsets - AT&T E5640 - 5.8GHZ Spec Answ System User Manual

91-000353-010-000_E5640_R4.qxd
Appendix

Adding new handsets

Your telephone can accommodate up to four cordless handsets. You can add new hand-
sets (E560-2, sold separately) to the E5640 and E5643B at any time, but each handset
must be registered with the base before use.
The handset provided with your E5640 is automatically registered as Handset 1.
Additional handsets will be assigned numbers in the order they are registered (Handset 2,
Handset 3, or Handset 4). You can register a maximum of 4 handsets.
The E5643B has 3 handsets automatically registered as Handset 1, 2 and 3. You can regis-
ter one additional handset, which will be assigned number 4.
The E5644B has 4 handsets automatically registered as Handsets 1,2 ,3 and 4. You cannot
register any additional handsets to the E5644B.
NOTE: You can replace E5644B handsets (see page 36).
Enter base ID, then press SELECT.
ENTER BASE ID
HANDSET 2
Handset 1 Handset 2 Handset 3
Handset 4
7/1/2005 12:25 PM
Before using a new E560-2 handset, you must register it
with the base. During registration, you must enter the
15-digit ID number of the telephone base. The Base ID is
located on the bottom of the base unit.
To add a new handset:
• Make sure your handset battery is properly installed
and charged.
• Your handset will display "ENTER BASE ID"
• Enter the 15-digit Base ID number from the bottom
of the base unit. (E5640 or E5643B)
• Press to accept the code and complete reg-
SELECT
istration.
NOTE: If an invalid Base ID code is entered you will hear an error tone
and the handset will continue to display "ENTER BASE ID". To make correc-
tions while entering the code, you can erase digits by pressing the DELETE
key.
Once a valid base ID code is entered and accepted , the
new handset will be assigned the next available handset
number (Handset 2, Handset 3, or Handset 4). You can
register a maximum of four handsets per base unit.
35
Page 35