TYAN Tempest i5400PW User Manual page 40

3.2.1 IDE Channel 0/1 Master/Slave Setup
Computer detects IDE drive type from drive C to drive F.
Press Enter on any of the Channel 0/Master, Channel 0/Slave, Channel 1/Master,
Channel 1/Slave options to view advanced details of the corresponding drive. The
system displays advanced details like the number of heads/cylinders/sectors on the
detected disk and the maximum storage capacity of the disk.
Main
IDE Channel 0 Master [None]
Type:
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
F1 Help
← →
Esc Exit
The system displays advanced details like the number of heads/cylinders/sectors on
the detected disk and the maximum storage capacity of the disk.
This option lets you set the following hard disk parameters:
Type
Selects the type of device connected to the system.
Options: Auto / CD/DVD / Not Installed / ARMD
Multi-Sector Transfers
This option allows you to specify the number of sectors per block for multiple sector
transfers.
Options: 16 Sectors / 2 Sectors / 4 Sectors / 8 Sectors /Disabled
LBA Mode Control
Enables or disables LBA Mode.
When LBA is turned on, the BIOS will enable geometry translation. This translation
may be done in the same way that it is done in Extended CHS or large mode, or it
may be done using a different algorithm called LBA-assist translation. The
translated geometry is still what is presented to the operating system for use in Int
PhoenixBIOS Setup Utility
Advanced
[Auto]
[Disabled]
[Disabled]
[Disabled]
[Standard]
[Disabled]
↑↓
Select Item
Select Menu
http://www.tyan.com
Security Power
-/+ Change Values
 Sub-Menu
Enter Select
40
Boot Exit
Item Specific Help
User = your enter
parameters of hard-disk
drive installed at this
connection.
Auto = autotypes hard-
disk drive installed here.
1-39 = you select pre-
determined type of
hard-disk drive installed
here.
CD-ROM = a CD-ROM
drive is installed here.
ATAPI Removable =
removable disk drive is
installed here.
F9 Setup Defaults
F10 Previous Values