Shoprider Cooper User Manual page 8

Seat Height Adjustment (Fig 5)
Remove seat as described (fig 4). Remove battery pack (refer to disassembly section).
Using hex key wrench (6mm) and stamped wench (13mm) to remove locking bolt and
nut from the seat post. Adjust seat post up or down to desired position. The seat height
can be adjusted to five different positions by inserting the locking bolt in the desired hole.
Replace washer and nut and tighten. Replace battery pack and seat.
Serial Number (Fig 5)
Serial number is located on the seat post. It is on a white sticker with a barcode. The
serial number is 13 alphanumerical digits beginning with a 1.
2 Wrenches to be
fetched from a
pouch attached with
this Owner's Manual
Armrest Width Adjustments (Fig 6)
On the underside back of the seat there are two arm
rest hand knobs, one on each side. Turn hand knobs
counterclockwise to loosen. Loosening the arm rest
hand knob allows the armrest width to be adjusted or
arm rest to be removed. Once the desired positions of
the arm rests are set, tighten the hand knobs by turning
clockwise to lock the arm rests into place.
Armrest Adjustments (Fig 6)
The arm rests are hinged and can be pulled up and out
of the way for sideways transfer. Pull arm rest up and
back.
Adjustment
Holes
Figure 5
8
Scooter
Serial
Number
Pull Arm Up
Arm Rest
Hand Knob
Figure 6
Seat
Post
Locking
Bolt