Attachment To A Bicycle - Medion Navigation Unit Manual

A
TTACHMENT TO A
You can attach your navigation system to a bicycle as an op-
tional additional feature. A special holder is needed to do this.
The installation is explained in the following.
Hexagon key
1. Release both the screws connecting the clamp to the hold-
ing plate with the hexagon key.
2. Remove the rubber ring and wind it
around the handlebars.
3. Position the clamp on your bicycle
handlebars, by pulling it across the
handlebars from below.
4. Put the holding plate back onto the clamp and retighten
both the screws.
5. Seat the holder for the navigation system on the holder
plate until it locks into place audibly. Please pay attention
to the fact that the holder must only be seated in one
direction.
6. Now place the device on the holder. You must pay attention
to firm positioning.
Note: The optional storage pocket will protect your
i
device against dust and dirt after the installation of
the bicycle holder. The pocket offers protection
against rain and damp. Take care that the navigation
system does not come into contact with moisture.
The electronic parts could be damaged in that case.
B
ICYCLE
Screws
Holding plate
A
PPENDIX
Clamp
47