The customer should not install, repair or replace any part of the dishwasher unless specifically recommended in the literature accompanying it. A qualified service technician should perform all other service. Contact the nearest Dacor authorized service representative at (800) 793-0093, or at www.Dacor.com for examination, repair or adjustment.
Important Safety Instructions To reduce the risk of fire, electric shock, serious injury or death when using the dishwasher, follow basic safety precautions, including the following: WARNING Do not install or operate this dishwasher if it has been damaged, dropped, has damaged electrical conduit or wires or is not working properly.
Preparing for Installation WARNING Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Planning the Location The floor must be level and all cut-out surfaces at right Carefully check the location where the dishwasher is to angles.
Preparing for Installation Power Supply Install the Plumbing • Install a water supply valve for the hot water supply WARNING line where it is easily accessible after the dishwasher is The electrical power supply for the dishwasher should installed. be installed only by a licensed electrician. •...
Small particle filter Medium particle filter Silverware basket Top rack Bottom rack Toe kick Use and care manual A bottle of Dacor Stainless Steel Cleaner is also included with model ED30. Make sure you have everything necessary for proper installation before proceeding.
Operation section. cord. If the power cord is damaged it must be replaced by a Dacor Authorized Service Agent, or similar qualified person, • Do not install the dishwasher unless the electrical in order to avoid a hazard.
Page 10
Installation Instructions Leveling the Dishwasher (continued) Install the Anti-Tip Brackets To adjust the rear leveling legs, rotate the #2 Phillips CAUTION drive shafts, located at the toe-kick, to level the dishwasher from front to back and left to right. • Make sure to anchor at least one anti-tip bracket on each side of the dishwasher.
See the included Custom Panel Installation Template (Dacor PN 101394) for complete installation instructions and dimensions of the custom panel and if desired, a custom toe kick. If the custom cabinet panel requires decorative door hardware, mount the hardware on the panel before proceeding to the next step.
Installation Instructions Water Line Connection Create loop and fasten to under WARNING side of cabinet • Any solder connections must be made before the dishwasher water line is connected. Do not solder within six inches of the inlet valve. Connect the hot water line from the dishwasher to the hot water supply valve.
The importance of proper installation of in damage to the dishwasher’s electrical system. your Dacor dishwasher cannot be overemphasized. Pre-verification Check List • Do not ground the dishwasher to the neutral (white) power supply wire.
Snap the toe kick assembly into the toe kick mounting authorized Dacor service company at (800) 793-0093. plate. Do not attempt to repair the appliance yourself. Dacor Install the entire toe kick assembly by inserting the is not responsible for service required to correct a faulty depth adjustment pins into the chassis and pushing installation.