Dacor EDWH24S Installation Instructions Manual
24-inch built-in dishwasher
Hide thumbs
Also See for EDWH24S:
- Use and care manual (24 pages) ,
- Installation instructions manual (19 pages) ,
- Planning manual (3 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Use and Care Manual
Advertisement
Table of Contents
Related Manuals for Dacor EDWH24S
Summary of Contents for Dacor EDWH24S
- Page 1 Installation Instructions 24 - Inch Built-in Dishwasher Models: EDWH24S and IDWH24 Part No. 106842 Rev. C...
-
Page 2: Table Of Contents
Phone: (800) 793-0093 (U.S.A. and Canada) Monday — Friday 6:00 . to 5:00 . Pacific Time Web site: www.Dacor.com All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. © 2010 Dacor, all rights reserved. -
Page 3: Important Safety Instructions
Hazards or unsafe practices that COULD result in • Always contact the Dacor Customer Service severe personal injury or death. Team about problems and conditions that you don’t understand. See Customer Service CAUtION Information. -
Page 4: General Safety Precautions
A qualified service technician • To prevent household mold and mildew should perform all other service. Contact the damage, periodically check the inlet and drain nearest Dacor authorized service representative hoses for leaks. for examination, repair or adjustment. -
Page 5: Product Specifications
Product Specifications Product Dimensions Product tolerances: ±1/16” (±1.6 mm) Style varies, model EDWH24S shown Depth with door open 49 3/4” (126.4 cm) D Handle depth Depth with door closed Drain hose Depth dimensions allow Side for hose on back of unit Front 5 1/4”... -
Page 6: Planning The Installation
• The dishwasher can be connected to a cold or page 11. hot water supply (maximum 140°F, 60°C). Dacor recommends using a hot water supply of 120°F Electrical Requirements (49°C) to 140°F (60°C). If a cold water supply is... -
Page 7: Preparing The Location
Call Dacor for the part number *Model IDWH24 requires installation of a trim kit of an approved edge protector. (Dacor PN 106925) to fill the space between the edge • The opening (E) through the partition between of the cutout and the dishwasher. -
Page 8: Preparing The Drain
• The drain connection must be a minimum of 20” spring kit (Dacor PN 701385). Maximum panel weight (50.8 cm) above the floor. with heavy duty springs: 23 pounds. •... - Page 9 Planning the Installation Air gap Disposer connection Disposer connection Keep higher Keep higher than disposer than disposer connection connection 20” min. 20” min. Sink trap Sink trap Floor Floor Disposer Installation without Air Gap Disposer Installation with Air Gap Waste tee Waste tee Air gap Keep higher...
-
Page 10: Installation Instructions
Installation Instructions Verify the Package Contents • Remove all styrofoam and plastic wrap from the dishwasher. Be sure to remove the toe kick from the top of the dishwasher packaging. With the assistance of at least one person, remove the dishwasher from the shipping pallet. -
Page 11: Installation Preparation
2 places Custom Door Panel Installation: Install the Dacor trim kit (PN 106925) on Exhaust vent, the dishwasher according to the instructions do not block accompanying it. -
Page 12: Adjust The Door Springs
Installation Instructions Handle Installation ( To make larger tension adjustments to the door Model EDWH24S springs, remove the back of the springs from the Install the door handle according to the handle dishwasher by turning them outwards. installation instructions. Move them one hole farther back or forward, then... -
Page 13: Level The Dishwasher
Installation Instructions Level the Dishwasher Open the door and pull the bottom rack out of the dishwasher. Check to make sure the dishwasher floor is level left to right using a level. Adjust the CAUtION front legs as necessary. A level unit is very important to proper operation. Using a flat blade screwdriver, turn the rear leg Be sure to level the unit front to back and side to adjustment screw until the floor of the dishwasher... -
Page 14: Installing The Unit In The Cabinet
Installation Instructions If a nonmetallic cable is being used, install a Slowly and gently slide the unit into the UL-listed strain relief bushing on the back of the dishwasher opening. As you do this, have dishwasher. someone gently pull the drain hose, water supply line and power cable through the access hole(s) Connect the white wire on the cable to the “N”... -
Page 15: Drain Connection
Pre-verification Check List • Repeat the Wet Test Checklist. • If the appliance still does not work, contact Dacor Confirm that the power cable is disconnected. Distinctive Service at (877) 337-3226. Do not Make sure all packing material has been attempt to repair the appliance yourself. -
Page 16: Final Leveling
Installation Instructions Final Leveling Attaching the Anti-tip Brackets Check to make sure that adjacent drawers and cupboards can be opened when the dishwasher door is open. Reposition the dishwasher if CAUtION necessary. Make sure to anchor one anti-tip bracket on each Check that there is a 1/8”... -
Page 17: Installing The Toe Kick
• Proper installation is the responsibility of Catch the homeowner. The importance of proper installation of your Dacor dishwasher cannot be overemphasized. □ Has the unit been inspected for cosmetic damage? □ Toe kick... - Page 18 Notes...
- Page 20 Item No., 80 895 92 Rev. 03 Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com...