If You Need Help... If you have questions or problems with installation, contact your Dacor dealer or the Dacor Customer Service Team. For repairs to Dacor appliances under warranty call the Dacor Distinctive Service line. Whenever you call, have the model and serial number of the appliance ready.
A qualified technician must complete the installation of this built-in appliance. The owner is responsible to make sure the dishwasher is properly installed. Improper connection of the electrical wiring may create an electric shock or fire hazard and may result in damage to the dishwasher’s electrical system.
The customer should not install, repair or replace any part of the dishwasher unless specifically recommended in the literature accompanying it. A qualified service technician should perform all other service. Contact the nearest Dacor authorized service representative for examination, repair or adjustment.
(see page 3). Dimensions shown provide minimum clearances, unless otherwise noted. The floor must be solid, level and all cut-out surfaces must be at right angles. The dishwasher must be secured to the adjacent cabinets using the anti-tip brackets for safety and proper operation.
• The water pressure must be between 20 and 120 psi (138-827 kPa). The household hot water heater must supply a minimum of 120 °F water to the dishwasher location for best results. • Install a valve for the hot water supply line where it is easily accessible after the dishwasher is installed.
• With the assistance of at least one person, remove the dishwasher from the shipping carton. Place the unit to the side of the cabinet opening. • Remove all of the packing materials from inside and outside of the unit.
To verify front to back level, remove the lower rack from the dishwasher and place a level on the tank side wall rack guides. To verify left to right level, place a level on the tank lower front frame.
Page 10
Front leg adjustment adjustment hex rod It is important to level the dishwasher from left to right and front to back. Shimming may be required on extremely uneven flooring materials. If shims are needed, place the shim(s) under the adjustable legs.
See the included Custom Panel Installation Template (Dacor PN 100394) for complete installation instructions and dimensions of the custom panel and if desired, a custom toe kick. If the custom cabinet panel requires decorative door hardware, mount the hardware on the panel before proceeding to the next step.
Drain tee Sink trap INStALLAtION WItH AIR GAP AND WAStE tEE Connect the water supply hose from the dishwasher to the hot water supply valve. Connect the flexible drain line to the air gap or directly to the drain tee or disposal above the sink trap as shown below.
If you need service, be sure to have the model and serial numbers available when you call. See the inside cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation.
Toe kick plate pins Installing a Custom Toe Kick (Model ID30) See the Custom Panel Installation Template (Dacor PN 100394) for complete installation instructions of a custom toe kick panel. Use the included stainless steel toe kick as a mounting surface.