Customer: Keep these installation instructions for future reference and the local electrical inspector's use. If you have questions or problems with installation, contact your Dacor ® dealer or the Dacor Customer Service Team. Product Data Label Location If You Need Help...
[_ WARNING • Always contact the Dacor Customer Service Team Hazards 0r Unsafe practices that COULD result in severe about problems and conditions that you don't personal injury or death.
A qualified service technician should perform all and seri0us injuryl other service. Contact the nearest Dacor authorized service representative for examination, repair or Store al detergents and rinse aids out of the reach of childrenl adjustment.
Product Dimensions Product tolerances: +1/16" (+1.6 mm),-0, unless otherwise stated 23 7/8" (606 mm) adjustible to 24 1/4" (616 mm)------_ 14 5/8" (371 mm) -_ From rear to junction box 3 1/4" (83 mm) 4" (102 mm) 12" from side to from side to (305 mm) --_ water inlet...
If the unit is to be placed in a corner, there must be at Preparing the Location least 2 inches between the opened door and the wall. The floor must be solid, level and all cut-out surfaces WARNING must be at right angles. The dishwasher must be secured to the adjacent cabinets using the anti-tip Electric Shock Hazard, Electrical, water and drain lines...
If an air gap is not required, the drain hose must be Plumbing Requirements installed to an inlet or waste tee above the drain trap in the household plumbing. If you connect to a sink drain, Drain Connection entry will need to be above the trap. Use a "Y" branch tailpiece and connector kit (not include) for this method.
Materials required for installation (not provided): Verify the Package Contents IMPORTANT: Do not use old parts. • Cut the shipping carton open and use it as a pad • 90 ° elbow (3/8" NPT external thread on one end, beneath the dishwasher until the legs are installed. opposite end sized to fit water supply) With the assistance of at least one person, place the •...
the Dishwasher for Plumbing Connections Preparing Installation Uncoil the drain hose in the back of the dishwasher. DO notcrossthedrain, W ater and electrical lines in front WARNING Do not remove the rear insulation blanket. Ofthe dishwashermotor or framel With the help of at least one other person, lay the I.
Page 11
Level the Dishwasher Locate the foam support between the motor and the liner on the bottom of the unit. Use two hands to rotate and slide the foam down and to the left to remove it. CAUTION Discard the foam. A level Unit is very imp0rtant for proper operati0n: Be sure to level the unit front to back and side to side.
Positioning the Unit in the Cabinet WARNING • Be careful not to pinch the wiring, hot water line and drain hose as you push the dishwasher into place. An electric shock hazard or water damage may result from pinched wires or hoses. Damage due to improper installation is not covered under the warranty.
This unit has copper lead wires. homeowner. The importance of proper installation of Verify that the power is turned off at the source. your Dacor dishwasher cannot be overemphasizedl Strip the necessary insulation off the wires in order to Pre-verification Check List make a good connection.
See the inside cover for location. Operate the machine through at least one fill and pump Dacor is not responsible for the cost of correcting problems out and check the following items: caused by a faulty installation.
Plates of the dishwasher frame. Drill pilot holes into the adjacent cabinets for the Your Dacor dishwasher has been equipped with adjustable provided mounting screws. stainless steel side trim plates. Each side can be adjusted independently to create a clean, integrated look with your Secure the anti-tip brackets on both sides to the cabinets.
Page 16
The Life of the Kitchen? Dacor • 1440 Bridge Gate Drive, Diamond Bar, CA 91765 • Tel: (800) 793-0093 • FAX: (626) 403-3130 • www.Dacor.com...