The customer should not install, repair or replace any part of the dishwasher unless specifically recommended in the literature accompanying it. A qualified service technician should perform all other service. Contact the nearest Dacor authorized service representative at (800) 793-0093, or at www.Dacor.com for examination, repair or adjustment.
Important Safety Instructions To reduce the risk of fire, electric shock, serious injury or death when installing or using the dishwasher, follow basic safety precautions, including the following: WARNING • Do not install or operate this dishwasher if it has been damaged, dropped, has a damaged electric cord or is not working properly.
* Allows for drain hose on back of unit Side View - Door Open Side View - Door Open Technical ED30 or ID30 – 29 7/8" (759mm) Water Pressure 20 to 120 psi (138 - 827 kPa) Water 120°F, minimum Temperature 120 Vac, 15 Amp., 60 Hz dedicated,...
Preparing for Installation Planning the Location The floor must be level and all cut-out surfaces at right Carefully check the location where the dishwasher is to angles. The dishwasher must be secured to the adjacent be installed. Place it in a location with convenient access. cabinets using the anti-tip brackets for safety and proper Make certain that electrical power can be provided in the operation.
Preparing for Installation Electrical Specifications Install the Plumbing • Install a valve for the hot water supply line where it is WARNING easily accessible after the dishwasher is installed. The • The electrical outlet for the dishwasher should be dishwasher water inlet hose is equipped with a 3/8” installed only by a licensed electrician.
Large particle filter Small particle filter Medium particle filter Use and care manual Toe kick A bottle of Dacor Stainless Steel Cleaner is also included with model ED30. Additional tools/materials required for installation: Make sure you have everything necessary for proper installation before proceeding.
Installation Instructions Installing the Unit in the Cabinet WARNING • Do not connect the electrical, water inlet or drain Care should be exercised when the appliance is installed or until instructed to do so in the Verifying Proper removed, to reduce the likelihood of damage to the power Operation section.
Page 10
Installation Instructions Attach the Anti-Tip Leveling the Dishwasher (continued) Brackets Remove the toe kick mounting plate to expose CAUTION the front legs. To adjust the front leveling legs, • Make sure to anchor at least one anti-tip bracket on place a wrench on the each side of the dishwasher.
See the included Custom Panel Installation Template (Dacor PN 101394) for complete installation instructions and dimensions of the custom panel and if desired, a custom toe kick. If the custom cabinet panel requires decorative door hardware, mount the hardware on the panel before proceeding to the next step.
Installation Instructions Water and Drain Line Connections Connect the water supply hose from the dishwasher to the hot water supply valve. WARNING Connect the flexible drain line to the air gap or directly to the drain tee or disposal above the sink trap as •...
Repeat the above test. hot water faucet at the sink. The water going to the • If the appliance still does not work, contact the Dacor dishwasher must be between 120ºF and 150ºF. Customer Service Team at (800) 793-0093. Wet Test Check List Do not attempt to repair the appliance yourself.
Plate Toe Kick Installing a Custom Toe Kick (Model ID30) See the Custom Panel Installation Template (Dacor PN 101394) for complete installation instructions of a custom toe kick panel. Use the included stainless steel toe kick as a mounting surface.
Need help?
Do you have a question about the ED30 and is the answer not in the manual?
Questions and answers