Table of Contents
Advertisement
INTRODUCTION
MANUAL CONTENTS
In addition to the introduction which includes a description of the explanatory notes used in the manual, general
safety information, how to unpack the printer and a brief description of the printer including its basic features,
this manual is organized as follows:
Chapter 1:
Contains the information required for correct printer installation and its proper use
Chapter 2:
Contains information on interface specifications
Chapter 3:
Contains a description of the printer command set
Chapter 4:
Contains Technical Specifications of the printer
Chapter 5:
Contains the character sets (fonts) used by the printer
EXPLANATORY NOTES USED IN THIS MANUAL
N.B.
Gives important information or suggestions relative to the use of the printer.
WARNING
Information marked with this symbol must be carefully followed to guard against damaging the
printer.
DANGER
Information marked with this symbol must be carefully followed to guard against operator injury or
damage.
GENERAL SAFETY INFORMATION
Read and keep the instructions which follow.
Follow all warnings and instructions indicated on the printer.
Before cleaning the printer, disconnect the power supply cable.
Clean the printer with a damp cloth. Do not use liquid or spray products.
Do not operate the printer near water.
Pay attention that the external frame, the cover and the printer frame are made from polypropylene, so it's
better to keep away from:
ammonia
acetone
benzol
hydrocarbon
perchloretylene
trichlorethylene
Do not use the printer on unstable surfaces that might cause it to fall and be seriously damaged.
Use the type of electrical power supply indicated on the printer label. If in doubt, contact your retailer.
Make sure the printer is placed in such a way as to avoid damage to its wiring.
Make sure that the maximum load absorbed by the printer does not exceed the approved Maximum load
by the type of cable used to supply.
Do not introduce foreign objects of any kind into the printer as this could cause a short circuit or damage
parts that could jeopardize printer functioning.
Do not spill liquids onto the printer.
Do not carry out technical operations on the printer, with the exception of the scheduled maintenance
procedures specifically indicated in the user manual.
Disconnect the printer from the electricity supply and have it repaired by a specialized technician when:
A. The feed connector has been damaged.
B. Liquid has seeped inside the printer.
C. The printer has been exposed to rain or water.
methanol
washing-up liquid
dishwasher liquid
dichloromethane
ethylene
toluene
1
Mini PLUS
Advertisement
Table of Contents
