Table of Contents
Advertisement
1.2 SELF-TEST
Printer operating status is indicated in the configuration print-out in which, next to the name of the components
displayed (see figure 1.2), the following information is given:
• under HEAD TEMPERATURE is given the temperature of the head.
• under HEAD VOLTAGE is given the voltage of the head.
1.3 CONFIGURATION
This printer permits the configuration of default parameters. The printer's configurable parameters are:
•
Baud Rate: 38400, 19200
•
Data length: 7, 8
D
•
Parity: None
D
, Even or Odd.
•
Handshaking: XON/XOFF
•
Autofeed: CR disabled
•
Columns: 24 col.
D
•
Print Mode: Normal
•
Char Mode: Normal
•
Print density: -2, -1, 0
Please note: the parameters marked with the symbol
The settings made are stored in nonvolatile memory and are loaded automatically .
During power-up, if the FEED key
setup report. The printer will remain in standby in Hexadecimal dump mode (see section 1.4) until another key
is pressed or characters are received through the printer communication port.
When the FEED key
is pressed, the printer enters parameter configuration. Each time the FEED key
(1)
pressed, the parameter will change and the current value will be printed out. Once the desired value has been
attained, hold the FEED key
out of a new printer set up report indicates that set up is complete.
NOTE
: The FEED key is external and must be connected to serial connector as indicated in
(1)
paragraph 2.1.
Mini PLUS
1. INSTALLATION AND USE
* PRINTER SETUP *
HEAD TEMPERATURE [ C]= 32.5
HEAD VOLTAGE [V]
Baud Rate
Data length
Parity
Handshaking
Autofeed
Columns
Print Mode
Chars Mode
Print Density
[PUSH]
ENTER SET-UP
[FAST PUSH]
EXIT
, 9600, 4800, 2400,1200, 600.
D
bits/car.
D
or Hardware.
or CR enabled.
D
, 40 col.
or Reverse.
D
D
, Double width (2 x Width), Double height (2 x Height), Expanded.
D
, +1, +2.
(1)
is held down, the printer enters the autotest routine and prints out the
down for at least a second to pass to the next parameter, and so on. Printing
(1)
= 5,0
: 38400 bps
: 8 bits/chr
: None
: Xon/Xoff
: CR disabled
: 24 col.
: Normal
: Normal
: 0
represent the default values.
D
1-
2
(Fig.1.2)
is
(1)
Advertisement
Table of Contents
