Yamaha BIGBEAR 250 Owner's Manual page 125

1. Battery
2. Battery bracket
3. Bolt
4. Positive lead
5. Negative lead
5. Remove the battery, fully charge it, and then
place it in a cool, dry place.
ECB00600
CAUTION:
Do not leave or store the battery on its side.
6. If the battery will be stored for more than two
months, check the specific gravity of the elec-
trolyte at least once a month and fully charge
the battery whenever necessary.
To install the battery
NOTE:
Be sure the battery is fully charged.
1. Install the battery.
2. Connect the positive lead.
3. Install the battery bracket by installing the
bolts.
4. Connect the negative lead.
5. Make sure that the breather hose is properly
routed, in good condition, and not obstructed.
1. Battery
2. Battery breather hose
3. Hose clamp
8-40
8