Yamaha BIGBEAR 250 Owner's Manual page 115

1. Locknut
2. Brake pedal position adjusting bolt
3. Brake pedal position
1. Remove the footboard. (See "Engine oil" on
page 8-11 for removal and installation proce-
dures.)
2. Loosen the locknuts at the brake pedal.
3. Turn the brake pedal position adjusting bolt at
the brake pedal in direction (a) to raise the
brake pedal, and in direction (b) to lower it.
4. Tighten the locknuts at the brake pedal.
Adjusting the brake pedal free play
The brake pedal free play should measure 20.0–
30.0 mm (0.79–1.18 in) as shown. If the free play
is incorrect, adjust it as follows.
1. Brake pedal free play
1. Fully loosen the brake lever free play adjust-
ing nut on the brake cable at the rear wheel
hub.
2. Turn the brake pedal free play adjusting nut
on the brake rod at the rear wheel hub in direc-
tion (a) to increase the free play, and in direc-
tion (b) to decrease it.
8-30
8