3. Install the footboard.
EBU24803
Adjusting the clutch free play
The clutch free play must be adjusted periodically.
Adjust the free play as follows.
1. Remove the footboard. (See "Engine oil" on
page 8-11 for removal and installation proce-
dures.)
2. Loosen the locknut.
3. Slowly turn the clutch adjusting screw in direc-
tion (a) until resistance is felt, and then turn it
1/8 turn in direction (b).
1. Locknut
2. Clutch adjusting screw
NOTE:
Turning the clutch adjusting screw in direction (a)
decreases clutch free play and turning it in direc-
tion (b) increases clutch free play.
4. Tighten the locknut to the specified torque.
Tightening torque:
Locknut:
15 Nm (1.5 m·kgf, 11 ft·lbf)
NOTE:
When tightening the locknut, hold the clutch ad-
justing screw with a screwdriver so that it does not
turn together with the locknut.
5. Install the footboard.
EBU24890
Checking and lubricating the cables
The operation and the condition of all control ca-
bles should be checked before each ride, and the
cables and cable ends should be lubricated if nec-
essary. If a cable is damaged or does not move
smoothly, have a Yamaha dealer check or replace
it.
8-34
8