Replacing A Turn Signal Light Bulb; Supporting The Motorcycle; To Service Front Wheel - Yamaha XT225T Owner's Manual

Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1
2
1. Turn signal light lens
2. Screw
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24201
1
1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
CAUTION:
Do not overtighten the screw, other-
wise the lens may break.

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
ECA11190
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
6-37
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
EAU24350
2
3
4
5
6
7
8
9