Replacing The Fuse - Yamaha XT225T Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
1
3. Fully charge the battery before in-
stallation.
2
4. After installation, make sure that
the battery leads are properly con-
3 nected to the battery terminals.
CAUTION:
4
G
Always keep
charged. Storing a discharged
5
battery can cause permanent
battery damage.
6
G
To charge a sealed-type (MF)
battery, a special (constant-volt-
7
age) battery charger is required.
Using a conventional battery
charger will damage the battery.
8
If you do not have access to a
sealed-type (MF) battery charg-
9
er, have a Yamaha dealer
charge your battery.

Replacing the fuse

ECA10630
1. Fuse
the battery
2. Spare fuse
The fuse holder is located behind panel
B. (See page 6-9.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
EAU23500
1
2
6-34
Specified fuse:
20.0 A
CAUTION:
Do not use a fuse of a higher amper-
age rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
ECA10640