Assembly And Setup - E-Wheels EW-36 Owner's Manual

1) Remove your EW-36/EW-66 from its shipping carton.
EW-36/EW-66 weighs about 150 lbs, so get help, and use
care. Cut away any residual packing materials with a knife
or scissors.
2) Attach the Rear View Mirrors to the mounting holes. A
wrench can be used to tighten the lock nuts at the base
of each mirror.
3) Check if the brakes are properly adjusted. The brake
handles should stop short of touching the handgrip, when
fully engaged. The rear brake cable can be adjusted in
two places:
At the cable end bracket, just before the lever,
•
with 8 and 10 mm wrench adjustments, and
At the end of the lever, with a 10 mm nut fastener.
•
The front brake is adjusted
at the end of the cable, at
the saddle nut.
4) Circuit Breaker. Using the ignition key, open the rear
storage compartment located under the seat. Locate the
circuit breaker and switch it from off to on.
5) Your EW-36/EW-66 has been in transit and storage.
You must charge the batteries before riding it. Charge
the battery by plugging the charger into the EW-36/
EW-66 Charger Ports.

ASSEMBLY AND SETUP

www.ActiveForever.com
14