6.15.5 Serial Com Station Address
Press the MENU key to access the menu data screens. Press the Down arrow key
to access the Run/Switch select screen.
Press the F1 key to display the following active adjustment screen:
6.15.6 Output Voltage Adjustment
While operating in the AC Input mode, press the MENU key for 4 seconds or more
to display the output voltage adjustment screen:
Press the F1 key to display the following active adjustment screen:
The fields marked ## will show the numerical value of the allowable voltage
adjustment parameter values. Press the Up/Down arrow keys to adjust the setting
±5 volts. This results in a ±2 % change in the output voltage.
Attempts to adjust this setting while the inverter is not running will result in the
following error message:
T O S H I B A
SER COM STATION ADDR
STATION ADDRESS:
>*F1: DATA SET MODE
> ∆/∇: PRV/NEXT SCREEN
SER COM STATION ADDR
STATION ADDRESS:
>∆/∇: CHANGE DATA
>ENTER: ACCEPT CHANGE
OUTPUT VOLT. ADJUST
OUTPUT VOLTAGE =###%
>F1: DATA SET MODE
> ∆/∇: PRV/NEXT SCREEN
OUTPUT VOLT. ADJUST
REFERENCE ADJUST: ##
>∆/∇: CHANGE DATA
>ENTER: ACCEPT CHANGE
OUTPUT VOLT. ADJUST
ADJUST PROHIBITED
DATA CANNOT CHANGE
> ∆/∇: PRV/NEXT SCREEN
54
31H
31H