Eft/Ept Type - TOHATSU MFS 30B Owner's Manual

MFG, EFG, EFT, EPT type
Power Tilt and Gas Assist type
Bolt
(12×105)
Washer
(small diameter)
A
Nut
Washer
(large diameter)
�������
!
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Notes
1. Apply sealing agent, such as
silicone sealed between the bolts
and the transom board holes before
tightening the bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 Nm (3.0kgf)13ft · lb)
�������
!
Mounting the outboard motor without
following this manual can lead to unsafe
conditions such as poor maneuverability,
lack of control or fire.
Loose clamp screws and/or mounting
bolts can lead to the release or
displacement of the outboard motor,
possibly resulting in lost of control and/or
serious personal injury. Be sure that
fasteners are tightened to the specified
torque (30 Nm (3.0kgf)13ft·lb). Check the
fasteners for tightness from time to time.
Be sure to use outboard mounting
fasteners included in the outboard
motor package or their equivalents
in terms of size, material, quality and
strength.
Tighten fasteners to the specified
torque (30 Nm (3.0kgf)13ft·lb). Test
cruise to check if fasteners are
tightened securely.
Outboard motor mounting must be
performed by trained service person(s)
using lift or hoist with sufficient capacity.
17
INSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13