Engine Operation; Before Starting; Starting - TOHATSU MFS 30B Owner's Manual

Tohatsu outboards
Hide thumbs Also See for MFS 30B:
Table of Contents

Advertisement

26

ENGINE OPERATION

Before starting

Before starting engine for the first time
1
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
2
out approximately 10 times in order to
prime the oil pump.
3

1. Starting

4
!
In case engine starts in gear, do not start
cruising. Stop engine immediately and
5
consult an authorized dealer.
6
Note
The engine will not start unless
7
the switch lock has been properly
connected into the emergency stop
switch.
8
!
9
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine
10
damage will result.
Loosen the air vent screw on the
11
tank cap.
12
13
14
�������
�������
Air Vent Screw
Attach the fuel connector to the
engine connector.
The arrow mark on the primer bulb
should be facing the engine.
Fuel Connector
Feed fuel to the carburetor by
squeezing the primer bulb until it
is firm.
Engine side
Be sure to install the stop switch
lock to the stop switch.
Stop Switch Lock
Stop Switch Lock
Fuel tank side

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents