TOHATSU MFS 30B Owner's Manual page 56

56 INSPECTION AND MAINTENANCE
!
You may be injured due to high engine
temperatures if you fill engine oil just
1
after stopping. Changing engine oil
should be done after the engine has
been cooled.
2
!
3
Do not overfill engine oil, or engine
oil could leak and/or engine could be
damaged. If engine oil level is over
4
upper limit marks of oil gauge, drain
oil to level lower than upper limit.
Be sure that outboard motor is in
upright and level position when
5
checking or changing oil.
Stop engine immediately if low oil
pressure warning lamp is lit or oil
6
leak is found, or engine could be
severely damaged. Consult dealer.
7
Notes
8
If any amount of water is found in
engine oil, making it milky white,
consult dealer.
If engine oil is contaminated with
9
fuel, emitting strong fuel smell,
consult dealer.
Some oil dilution is normal if
10
engine is idled or trolled for long
periods, especially in cooler water
temperatures.
11
12
13
14
�������
�������
Replacing oil filter
Drain oil from the engine.
Place a rag or towel below the oil
filter to absorb any spilled oil.
Unscrew old filter by turning the
filter to the left.
Clean the mounting base. Apply
film of clean oil to filter gasket.
Do not use grease. Screw new filter
on until gasket contacts base, then
tighten 3/4 to 1 turn.
P/N 3AC-99090-0
P/N 3AC99090M
(US.CANADA Only)
Oil filter
High pressure fuel filter
Oil filter wrench
Fuel filter