TOHATSU MFS 20C Owner's Manual page 48

48
INSPECTION AND MAINTENANCE
Replacing the anode
The anode protects the outboard
m o t o r f r o m g a l v a n i c c o r r o s i o n
1 (metal corrosion caused by feeble
electoricity).
Anodes are installed under the unti-
2
ventilation of the gear case, the left
cramp bracket (port side) and the left
mount bracket (port side).
3
When an anode is worn down under
2/3 of its original size (of new port),
replace it.
4
Notes
5
Never grease or paint the anode.
At each inspection re-tighten the
anode attaching bolt. As it is likely
to be subjected to electrolytic
6
corrosion.
7
8
9
10
11
Anode
12
13
14
Anode
(Trim tab)
Anode
Anode
Checking and Refilling Oil in the
Power Trim & Tilt.
Check the oil level of the reservoir
tank as shown on the right while
the tank is kept in a ver tical
position. Tilt the outboard motor up
to check the oil level in the tank.
Remove the oil cap by turning
counter-clockwise, then check if
the oil level reaches the bottom
line of the plug hole.
Oil cap
�������
!
Be sure that outboard motor is
secured to transom or service
stand, or accidental drop or fall of
outboard motor could lead to severe
personal injury.
Be sure to lock outboard motor if
it is tilted up, or accidental fall of
outboard motor could lead to severe
personal injury.
Do not go under outboard motor
tilted up and locked, or accidental
fall of outboard motor could lead to
severe personal injury.
Oil level