Drinks Dispenser - Zanussi ZI 920 FF Instruction Booklet

Drink dispenser
The container for cooling drinks is located in the door
of the fridge. It is easily removed from its runners for
filling and cleaning by pushing it upwards from the
left side and then by pulling sharply outwards.
Remove the clip on lid to fill. To pour a drink, press a
glass upwards against the tap arms. To stop the flow
of liquid remove the glass.
Before using the dispenser, we recommend that you
rinse it several times with hot water. For thorough
cleaning of the container add a spoonful of
bicarbonate of soda to the rinsing water. Push the
dispenser tap on and off several times to allow sugar
deposits from soft drinks or wines to dissolve, or
alternatively remove for cleaning by unscrewing in
an anticlockwise direction. Empty the container and
rinse thoroughly with clean water.
If using the dispenser to store fresh fruit juice,
particular attention should be paid to the
manufacturerÕs storage instructions. It is also
advisable to clean the dispenser thoroughly between
every filling, using a sterilising solution.
8
D115
INSTALLATION
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on ÒDoor reversal directionsÓ.
Positioning
This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located at the left on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification:
SN + 10 ¡ C to + 32 ¡ C
N + 16 ¡ C to + 32 ¡ C
ST + 18 ¡ C to + 38 ¡ C
T + 18 ¡ C to + 43 ¡ C
It should be located in a dry atmosphere, out of
direct sunlight and away from extreme temperature
e.g. not next to a boiler or radiator, or in a very cold
room e.g. an outhouse . If these temperatures are
exceeded i.e. colder or warmer, then the appliance
may not operate correctly.
For building-in and door reversibility, if necessary ,
refer to the relevant instructions in the following
pages.
Important
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
17