Related Manuals for Zanussi ZI 920 K
Summary of Contents for Zanussi ZI 920 K
- Page 1 REFRIGERATOR- FREEZER ZI 920/9 K © Electrolux Household Appliances Limited 2000 INSTRUCTION BOOKLET 2222 124-78...
-
Page 2: Important Safety Information
Refer to your local ¥ Do not allow children to tamper with the controls Zanussi Service Force Centre and always insist or play with the product. on genuine spare parts. ¥... -
Page 3: Table Of Contents
Apply covers (B) on joint cover lugs and into hinge CONTENTS holes. Instructions for the User Instructions for the Installer Important Safety Information Technical Specification Description of the Appliance D726 Installation Operation Positioning Before use Setting the temperature Electrical Connection Separate parts A, B, C, D as shown in the figure The freezer compartment Door Reversal... -
Page 4: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE Furthermore, it is necessary that the cabinet has a ventilation recess with the following dimensions: depth 50 mm width 540 mm PR01 Push appliance into housing until stop strip (A) touches the kitchen unit. FAS T FRE EZE D023 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance... -
Page 5: Freezing Fresh Food
OPERATION Instructions for totally built-in appliances Door reversal Before using Pay careful attention not to exceed load limit stated on the side of the upper section (where Remove all securing tapes. Wash inside the applicable). appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). -
Page 6: Thawing
A replacement cover/carrier must be obtained from longer. WARNING: THIS APPLIANCE MUST BE Do not cover the shelves with any protective your local Zanussi Service Force Centre. EARTHED. Any frozen food which is allowed to thaw material, such as paper, cardboard or plastic, which This appliance complies with the E.E.C. -
Page 7: Movable Shelves
INSTALLATION Movable shelves The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie Warning over the rear ones. IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN... -
Page 8: Drinks Dispenser
TECHNICAL SPECIFICATIONS Drink dispenser The container for cooling drinks is located in the door of the fridge. It is easily removed from its runners for filling and cleaning by pushing it upwards from the left side and then by pulling sharply outwards. POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz Remove the clip on lid to fill. -
Page 9: Hints And Tips
In the Event of a Power Failure We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair ¥... -
Page 10: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Changing the light bulb out, DISCONNECT the appliance from the ELECTRICITY supply. Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows;... - Page 11 Remember to wash the defrost cleaner in hot soapy water at regular intervals. Dry throughly before replacing. Freezer When the frost has reached a thickness of up to 4mm it can be removed using the ice scraper provided with the appliance. During this operation it is not necessary to disconnect the appliance from the mains and remove the food.
-
Page 12: Something Not Working
The freezer door will not open Has door just been opened? If so leave for a few For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, minutes to allow the air pressure to equalise. please contact our Customer Care Department by letter or telephone at the address below or visit our website...
Need help?
Do you have a question about the ZI 920 K and is the answer not in the manual?
Questions and answers