IMPORTANT SAFETY INFORMATION It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information.
Open the appliance door and the furniture door at CONTENTS 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¿ 2 mm at 8 mm from the outer edge of the door.
DESCRIPTION OF THE APPLIANCE Apply covers (B) on joint cover lugs and into hinge holes. D726 Separate parts A, B, C, D as shown in the figure FAS T FRE EZE PR266 Place guide (A) on the inside part of the furniture door, in the upper and lower position as shown in the figure and mark the position of external holes.
OPERATION Furthermore, it is necessary that the cabinet has a ventilation recess with the following dimensions: depth 50 mm width 540 mm Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger.
Fresh food refrigeration Instructions for totally built-in appliances Warning To obtain the best performance, do not store warm Do not put carbonated liquids, (fizzy drinks etc.), in food or evaporating liquids in the refrigerator; do the freezer compartment. cover or wrap the food, particularly if it has a strong Door reversal flavour.
A replacement cover/carrier must be obtained from WARNING: THIS APPLIANCE MUST BE your local Zanussi Service Force Centre. EARTHED. This appliance complies with the E.E.C. Directive The manufacturer declines any liability should No. 87/308 of 2.6.87 relative to radio interference this safety measure not be observed.
INSTALLATION Drink dispenser The container for cooling drinks is located in the door of the fridge. It is easily removed from its runners for filling and cleaning by pushing it upwards from the Warning left side and then by pulling sharply outwards. IF YOU ARE DISCARDING AN OLD APPLIANCE Remove the clip on lid to fill.
TECHNICAL SPECIFICATIONS HINTS AND TIPS Food Storage ¥ Try to avoid keeping the door open for long periods, or opening the door too frequently as POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz ¥ To obtain the best results from your appliance, warm air will enter the cabinet, and cause the neither hot foods nor liquids which may TOTAL POWER ABSORBED...
Standard guarantee conditions out, DISCONNECT the appliance from the We, Zanussi, undertake that if within 24 months of the date of the purchase this Zanussi appliance or any part ELECTRICITY supply. thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair...
SOMETHING NOT WORKING Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Before contacting your local Service Force Centre, check the following points: Symptom Solution No power to the appliance...
The purchase date CUSTOMER CARE DEPARTMENT For general enquiries concerning your Zanussi appliance or for further information on Zanussi products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk...
Need help?
Do you have a question about the ZI 920 FF and is the answer not in the manual?
Questions and answers