Table of Contents
Advertisement
Electrical connections
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability should
this safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should be
plugged into a 13amp socket in another part of your
home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
- Earth
Blue
- Neutral
Brown
- Live
If you fit your own plug, the colours of the wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
GREEN & YELLOW
13 AMP. FUSE
BROWN
BLUE
CORD CLAMP
D207
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
ÇEÈ or the earth symbol
or coloured green and
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter ÇNÈ or coloured
black.
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter ÇLÈ or coloured
red.
The plug moulded onto the lead incorporates a fuse.
18
For replacement, use a 13amp BSI362 fuse. Only
ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is
lost. The cover/carrier is indicated by the coloured
insert at the base of the plug.
A replacement cover/carrier must be obtained from
your local Zanussi Service Force Centre.
This appliance complies with the E.E.C. Directive
No. 87/308 of 2.6.87 relative to radio interference
suppression.
This appliance complies with the following
E.E.C. Directives:
-
73/23 EEC of 19.2.73 (Low Voltage Directive)
and subsequent modifications;
-
89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Please ensure that when the appliance is
installed it is easily accessible for the engineer in
the event of a breakdown.
Movable shelves
The walls of the refrigerator have runners so that the
shelves can be positioned as desired .
For better use of space, the front half-shelves can lie
over the rear ones.
Positioning the door shelves
To permit storage of food packages of various sizes,
the door shelves can be adjusted in height. To do
this proceed as shown in the diagram.
The top shelf can be removed for easier cleaning.
Drink dispenser
The container for cooling drinks is located in the door
of the fridge. It is easily removed from its runners for
filling and cleaning by pushing it upwards from the
left side and then by pulling sharply outwards.
Remove the clip on lid to fill. To pour a drink, press a
glass upwards against the tap arms. To stop the flow
of liquid remove the glass.
Before using the dispenser, we recommend that you
rinse it several times with hot water. For thorough
cleaning of the container add a spoonful of
bicarbonate of soda to the rinsing water. Push the
dispenser tap on and off several times to allow sugar
deposits from soft drinks or wines to dissolve, or
alternatively remove for cleaning by unscrewing in
an anticlockwise direction. Empty the container and
rinse thoroughly with clean water.
If using the dispenser to store fresh fruit juice,
particular attention should be paid to the
manufacturerÕs storage instructions. It is also
advisable to clean the dispenser thoroughly between
every filling, using a sterilising solution.
D338
D007
D009
D115
7
Advertisement
Table of Contents
